Nice RUN 2500I electromechanical gear motor,
3x400V AC, with built-in control unit, with electromechanical limit switch,
for sliding gates weighing up to 2500 kg
Nice RUN 2500I
Suitable to operate in extreme
conditions, in systems for intensive
use.
RUN2500I version with built-in inverter
Simple to install: the BlueBUS system
enables connections by means of just two wires between the control unit and up
to 15 control safety and signalling devices.
Safe: the acceleration settings (at the
start of the manoeuvre) and the deceleration settings (at the end of the
manoeuvre) are precise and reliable.
The temperature sensor: Run is able to
manage force, adapting it to the different climatic and environmental
conditions, while adapting the thermal cut-out protection and intensity of
self-ventilation, depending on the temperature reading.
A
master/slave selection also
automatically synchronises 2 motors, enabling the automation of sliding gates
with two opposing leaves.
Practical and functional: the control
unit and inverter, housed inside Run, can be simply connected by means of the
practical connector guide.
Very quiet: gear motor on bearings.
Perfect movement: the inverter enables
the power supply and drive of the 3-phase motor with single-phase current at
3x400V AC, acting on the frequency to adjust speed of the automation from a
minimum of 3,6 m/min to maximum 15,0 m/min.
In the automation deceleration phase, the inverter, which dialogues with the
control unit, increases the torque, thus improving performance and reducing the
risk of the automation blocking on impact with obstacles.
ACCESSORIES COOPERATING WITH THE DRIVE
